Our process

How it works

Every Brush project runs the same three steps, with one accountable crew the whole way through — no hand-offs, no split responsibility, no surprises.

  1. 1Book a free visit
  2. 2Get your written quote
  3. 3We prep, paint & walk through

Your written quote follows the visit — usually within two business days. The four steps below show what happens inside each one.

1

Survey & estimate

We come to you, look at the actual walls, and follow up with a clear written quote — free, and usually within two business days.

Every project starts on site. A Brush estimator visits your space, checks the condition of the surfaces, measures up, and talks through how each room is used and the look you're after.

Seeing the real walls matters: cracks, water stains, prior coatings, and traffic levels all change the work involved. From that visit you get a clear written quote — usually within two business days — with no online guesswork and no surprises on the invoice later.

2

Prep & protection

We protect floors and furniture, then fill, sand, caulk, and prime so the finish bonds properly and lasts.

This is the step that makes a paint job last. Before any colour goes up we cover and protect your floors and furniture, then repair the surface — filling holes and cracks, sanding smooth, caulking gaps, and spot-priming bare or stained areas so coatings bond properly.

Skipping prep is why finishes crack, peel, and show every flaw. We treat preparation as the real job, not an afterthought — which is why our walls still look right years later.

3

Painting

We cut clean lines by hand and apply quality coats — tidy work, around your schedule, walls dry by morning.

With the prep done, the crew cuts clean, crisp lines by hand and rolls or sprays even, quality coats using coatings matched to the surface and the use — low-odour interior paints and weather-tough exterior coatings.

We work tidily and around your schedule, residential or commercial, and keep the site clean each day. Most interiors are two coats with walls dry by morning, so the disruption is brief and the finish is built to hold up.

4

Walkthrough & touch-ups

We walk the job with you, fix any touch-ups on the spot, and leave the space cleaner than we found it.

Before we call it done, we walk the finished work with you in good light and check every edge, corner, and coat. Anything that needs a touch-up gets handled on the spot — not added to a list for later.

Then we remove our protection, clean up fully, and leave the space tidy. You have one point of contact if anything comes up afterwards, because the same accountable team saw the project through from the first visit.

Start with a free visit

Tell us about your space and we'll book the first visit. Your written quote follows — usually within two business days, with no obligation.